Please understand I am a novice to the particularities of the programing language used here and am just learning by experimentation and so my nomenclature may be wrong. This include most of the 2016 models and newer.
INTEGRA SERIAL COMMUNICATION PROTOCOL HOW TO
Since yours works for one command, it would suggest that http with port 80 is correct and possibly an older model using the Heos CLI protocol.Īlthough I have not figured out how to use the Heos CLI command set, I have gotten the IP commands to successfully control the Marantz receiver! I think this will work for all the Marantz AV receivers and preamps that have the Heos control built in. The Marantz responds to commands from Alexa and I can see the device webpage from a windows browser - But I can not access it via ISY.ĭoes anybody have any other ideas on what the cause is or what I can try?ĭavid-4 was told by Marantz that port 80 with HTTP was not supported on his model and needs to use TCP (probably) with the telnet ports 23 or 1255 as instructed. I have rolled back to an earlier firmware, rest and updated and reset again. I have done a factory rest to the Marantz. I can ping the Marantz and telenet to port 80 and port 8080. I have tried everything I can think of and still I get the 403 error. In the meantime can anyone help me figure out how to use these new commands in our ISY? I hope to get more info from Marantz support soon.
Apparently it has been superseded with a new HEOS protocol: HEOS_CLI_PROTOCOL_Specification_160218.pdf. The spreadsheet Marantz_FY16_AV_SR_NR_PROTOCOL_V01(2).xls we have all relied on for control commands is no longer listed as a support document for these models. The SR7011, SR6012, SR7012 and SR8012 are all HEOS based receivers. Hope this clears up some of the mystery, apologies!" "The SR7012 is a HEOS based model, these models do NOT have web control capabilities hence the error message you were receiving. According to a Tier II Technical Support Specialist:
0 kommentar(er)
